Table of Contents
Advertisement
TRENDnet User's Guide
Wireless Network Expansion
The network manager can configure related wireless settings, General Settings,
Advanced Settings and WDS Settings.
General Setup
The administrator can change the data transmission, channel and output power settings
for the system. Please click on Wireless -> General Setup and follow the below setting.
MAC Address : The MAC address of the Wireless interface is displayed here.
Band Mode : Select an appropriate wireless band; bands available are 801.11a or
802.11a/n mixed mode.
Transmit Rate Control : Select the desired rate from the drop-down list; the options
are auto or ranging from 6 to 54Mbps only for 802.11a mode.
Tx Power : You can adjust the output power of the system to get the appropriate
coverage for your wireless network. Specify digit number between 1 to 100 (the
unit is %) for your environment. If you are not sure which setting to choose, then
keep the default setting, 100%.
When Band Mode select in 802.11a only mode, the HT(High Throughput) settings
should be hidden immediately.
HT TxStream/RxStream : By default, it's 2.
© Copyright 2012TRENDnet. All Rights Reserved.
Operating Mode : By default, it's Mixed mode
Mixed Mode : In this mode packets are transmitted with a preamble
compatible with the legacy 802.11a/g, the rest of the packet has a new format.
In this mode the receiver shall be able to decode both the Mixed Mode
packets and legacy packets.
Green Field : In this mode high throughput packets are transmitted without a
legacy compatible part.
Channel Bandwidth : The "20/40" MHz option is usually best. The other option is
available for special circumstances.
Guard Interval : Using "Auto" option can increase throughput. However, it can also
increase error rate in some installations, due to increased sensitivity to radio-
frequency reflections. Select the option that works best for your installation.
MCS : This parameter represents transmission rate. By default (Auto) the fastest
possible transmission rate will be selected. You have the option of selecting the
speed if necessary. (Refer to Appendix C. MCS Data Rate)
Reverse Direction Grant(RDG) : Disable or enable reserve direction grant. Default is
enabled.
A-MSDU : Aggregated Mac Service Data Unit . Select Enable to allow aggregation
for multiple MSDUs in one MPDU Default is disabled.
Auto Block ACK : Disable or enable auto block ACK. Default is enabled.
Decline BA Request : Disable or enable decline BA request. Default is disabled.
Change these settings as described here and click Save button to save your changes.
Click Reboot button to activate your changes. The items in this page are for AP's RF
general settings and will be applied to all WDS Links.
TEW-676APBO
30
Advertisement
Table of Contents
