Table of Contents
Advertisement
TRENDnet User's Guide
Wireless MAC Filter Setup
Continue 7.3.1 Repeater AP Setup section, the administrator can allow or reject clients
to access Repeater AP.
MAC Filter Setup : By default, it's "Disable". Options are Disable, Only Deny List
MAC or Only Allow List MAC.
Two ways to set MAC filter rules :
Only Allow List MAC.
The wireless clients in the "Enable" list will be allowed to access the Access Point;
All others or clients in the "Disable" list will be denied.
Only Deny List MAC.
The wireless clients in the "Enable" list will be denied to access the Access Point; All
others or clients in the "Disable" list will be allowed.
Add a station MAC : Enter MAC address (e.g. aa:bb:cc:00:00:0a) and click "Add"
button, then the MAC address should display in the "Enable" List.
There are a maximum of 20 clients allowed in this "Enable" List. The MAC addresses of
the wireless clients can be added and removed to the list using the Add and Remove
buttons.
Click Reboot button to activate your changes
© Copyright 2012TRENDnet. All Rights Reserved.
System Status
This section breaks down into subsections of System Overview, Associated Clients
Status, Remote AP, Extra Information and Event Log.
System Overview
Display detailed information of System, Network, LAN and Wireless in the System
Overview page.
System : Display the information of the system.
System Name : The name of the system.
Operating Mode : The mode currently in service.
Location : The reminding note on the geographical location of the system.
Description : The reminding note of the system.
Firmware Version : The current firmware version installed.
Firmware Date : The build time of the firmware installed.
Device Time : The current time of the system.
System Up Time : The time period that system has been in service since last
reboot.
TEW-676APBO
93
Advertisement
Table of Contents
