Displaying And Maintaining Ipv6 Static Routes; Ipv6 Static Routing Configuration Examples; Basic Ipv6 Static Route Configuration Example - HP HPE FlexNetwork 7500 series Configuration Manual

Step
2. Configure the
source address of
echo packets.
3. Configure BFD echo
mode for an IPv6
static route.

Displaying and maintaining IPv6 static routes

Execute display commands in any view.
Task
Display IPv6 static route information.
Display IPv6 static route next hop
information.
Display IPv6 static routing table information.

IPv6 static routing configuration examples

Basic IPv6 static route configuration example

Network requirements
As shown in
Command
bfd echo-source-ipv6 ipv6-address
ipv6 route-static [ vpn-instance
s-vpn-instance-name ] ipv6-address
prefix-length interface-type interface-number
next-hop-address bfd echo-packet
[ bfd-source ipv6-address ] [ preference
preference ] [ tag tag-value ] [ description
text ]
Figure 91, configure IPv6 static routes so that hosts can reach one another.
Command
display ipv6 routing-table protocol static [ inactive |
verbose ]
display ipv6 route-static nib [ nib-id ] [ verbose ]
display ipv6 route-static routing-table [ vpn-instance
vpn-instance-name ] [ ipv6-address prefix-length ]
397
Remarks
By default, the source address
of echo packets is not
configured.
The source address of echo
packets must be a global
unicast address.
For more information about
this command, see High
Availability Command
Reference.
By default, BFD echo mode for
an IPv6 static route is not
configured.
The next hop IPv6 address
must be a global unicast
address.