Cut The Output And Clean Cut A Roll Of Media - Oce TCS500 User Manual

Cut the output and clean cut a roll of media

Cut the output and clean cut a roll of media
Introduction
The off-line screen of the printer operator panel contains the 'Feed & cut' wizard that
helps you do the following.
Cut the output.
Clean cut a roll of media. Use this option to cut the roll so that the edge is straight.
Note: You can only use the 'Feed & cut' wizard to cut the output when 'Automatic
media cut' is disabled in the Océ Settings Editor. When 'Automatic media cut' is
enabled in the Océ Settings Editor, the system automatically cuts the output.
How to use the Feed & cut wizard to cut the output.
Press the On-line / off-line key to set the printer off-line.
1.
Use the upper softkeys to scroll to the 'Feed & cut' card.
2.
[121]
Press the softkey below the 'Feed & cut' card to enter the wizard.
3.
The screen displays the message 'Preparing Feed & cut...'. The system prepares for
the feed and cut. This can take between 0 and 20 seconds.
[122]
Press the key for 'Feed' to feed the output in steps of 5 cm.
4.
154 Chapter 6 Use the Océ TCS500 for print jobs