LVPS card assembly removal (5230n/dn)
WARNING: When replacing the LVPS card assembly, ensure that the voltage selection switch is set to the
proper setting, or damage will occur.
1. Remove the door assembly, rear. Go to
2. Remove the side cover, right. Go to
3. Disconnect the connector (A) from the LVPS card assembly.
4. Remove the two screws (B) from the LVPS card assembly.
5. Gently pull the LVPS card assembly from the machine.
4-28
Service Manual
"Door assembly, rear removal" on page
"Side cover, right removal (5230n/dn)" on page
B
A
4-14.
4-67.
B