To run the Sensor Test for the standard bin:
1. Touch
2. Touch
3. Manually actuate the bin sensor by moving the flag in and out of the sensor, and the display changes.
The following screen is displayed:
Bin Empty: empty or Bin Empty: full.
4. Press Stop
BASE SENSOR TEST
This test is used to determine if the sensors located inside the printer are working correctly.
To run the Base Sensor Test:
1. Select BASE SENSOR TEST from the DIAGNOSTICS menu.
The following sensors are listed:
•
Toner Level– Toner level sensor (remove the cartridge and replace to actuate the sensor)
•
Input– Input sensor
•
Output– Output (exit) sensor
•
NarrowMedia– Output (exit) sensor
•
Front Door– Front door sensor
2. Manually actuate the sensors to verify that each sensor switches from Open to Closed.
3. Press Stop
3-42
Service Manual
to select Sensor Test from OUTPUT BIN TESTS.
to select Standard Bin from Sensor Tests.
to exit the test.
to exit the test.