Dell 5230dn Mono Laser Printer Service Manual page 128

Service manual
Hide thumbs Also See for 5230dn Mono Laser Printer:
Table of Contents

Advertisement

Error
code or
message
922.29
922.30
922.31
2-94
Service Manual
Error contents
Fuser warm-up failure
Fuser type = 2
After hot roll lamp
detection, did not roll
over to steady state
control in time.
Fuser type = 2
Fuser warm-up failure
Fuser type = 2
Description/Action
The fuser hot roll has timed out
and not reached "final lamp
detection" during the specified
time.
The control code has gotten
lost (this should really be a
software error.
The fuser hot roll did not reach
operating temperature within
new enhanced control.
Possible repair actions
1. Turn the machine off/on
and ensure the fuser unit
assembly is properly
installed.
2. Ensure the proper voltage
fuser is installed in the
machine.
3. Check all connections on
the fuser and LVPS card
assembly.
4. Replace the fuser unit
assembly if problem
"Fuser unit
remains. Go to
assembly removal" on
page
4-22.
5. Replace the LVPS card
assembly if problem
"System
remains. Go to
card assembly removal"
on page 4-76
"LVPS
or
card assembly removal
(5350dn, 5530dn, and
T656)" on page
4-30.
Turn the machine off/on.
1. Turn the machine off/on
and ensure the fuser unit
assembly is properly
installed.
2. Ensure the proper voltage
fuser is installed in the
machine.
3. Check all connections on
the fuser and LVPS card
assembly.
4. Replace the fuser unit
assembly if problem
remains. Go to
"Fuser unit
assembly removal" on
page
4-22.
5. Replace the LVPS card
assembly if problem
remains. Go to
"System
card assembly removal"
on page 4-76
or
"LVPS
card assembly removal
(5350dn, 5530dn, and
T656)" on page
4-30.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5230n5530dn5350dn

Table of Contents