Dell 5230dn Mono Laser Printer Service Manual page 129

Error
code or Error contents
message
922.32 Fuser warm-up failure
Fuser type = 2
922.50 Fuser warm-up failure
Fuser type = 1
Fuser page count has
exceeded life.
922.52 Fuser warm-up failure
Fuser type = 1
Fuser page count has
exceeded life.
922.53 Fuser warm-up failure
Fuser type = 1
Fuser page count has
exceeded life.
922.54 Fuser warm-up failure
Fuser type = 1
Fuser page count has
exceeded life.
922.56 Fuser warm-up failure
Fuser type = 1
Fuser page count has
exceeded life.
922.57 Fuser warm-up failure
Fuser type = 1
Fuser page count has
exceeded life.
Description/Action
The fuser hot roll does not
reach operating temperature
after increasing interpage gap.
The fuser hot roll failed to
reach target temperature.
The fuser hot roll does not
reach the "beginning lamp
detection" parameter in the
specified time.
The fuser hot roll does reach
the "final lamp detection"
parameter but not in the
specified time.
The fuser hot roll has timed out
and not reached "final lamp
detection" during the specified
time.
The fuser hot roll did not reach
operating temperature within
new enhanced control.
The fuser hot roll does not
reach operating temperature
after increasing interpage gap.
Possible repair actions
1. Turn the machine off/on
and ensure the fuser unit
assembly is properly
installed.
2. Ensure the proper voltage
fuser is installed in the
machine.
3. Check all connections on
the fuser and LVPS card
assembly.
4. Replace the fuser unit
assembly if problem
"Fuser unit
remains. Go to
assembly removal" on
page 4-22.
5. Replace the LVPS card
assembly if problem
"System
remains. Go to
card assembly removal"
on page 4-76 "LVPS
or
card assembly removal
(5350dn, 5530dn, and
T656)" on page 4-30.
Replace the fuser unit
assembly if problem remains.
Go to "Fuser unit assembly
removal" on page 4-22.
Replace the fuser unit
assembly if problem remains.
"Fuser unit assembly
Go to
removal" on page 4-22.
Replace the fuser unit
assembly if problem remains.
Go to "Fuser unit assembly
removal" on page 4-22.
Replace the fuser unit
assembly if problem remains.
"Fuser unit assembly
Go to
removal" on page 4-22.
Replace the fuser unit
assembly if problem remains.
Go to "Fuser unit assembly
removal" on page 4-22.
Replace the fuser unit
assembly if problem remains.
Go to "Fuser unit assembly
removal" on page 4-22.
Diagnostic information
2-95