Sheet Option Drive Shaft With Spring Removal; Anti-Tip Latch Assembly Removal - Dell 5230dn Mono Laser Printer Service Manual

550-sheet option drive shaft with spring removal

1. Remove the 550-sheet frame assembly. Go to
2. Pinch the two hooks (A) on the cap, and detach it from the 550-sheet frame.
3. Pull the drive roll gear (B), the shaft with spring (C), and the bevel out through the opening.
4. Remove the 550-sheet option drive shaft with spring.

Anti-tip latch assembly removal

Note: Carefully remove the base machine from the input option tray assembly before proceeding.
The left and right anti-tip latch assemblies are the same, and only one is in a package. The instructions below
are for removing the left latch, but removing the right latch is similar.
1. Remove the 250-sheet media tray assembly. Go to
4-114
Service Manual
"Media size actuator removal" on page
A
A
B
C
"250-sheet option tray assembly" on page
4-160.
A
4-102.