Dell 5230dn Mono Laser Printer Service Manual page 151

Service manual
Hide thumbs Also See for 5230dn Mono Laser Printer:
Table of Contents

Advertisement

Error
code or
Error contents
message
985.07
Service engine RFID
communications
990.00
Output option
equipment check.
990.02
Paperport failure
990.03
Paperport failure
990.04
Paperport failure
990.06
Paperport failure
990.09
Paperport failure
990.10
Paperport failure
Description/Action
Antenna is disconnected
Output option rear door not
fully closed.
Invalid paperport parameter
Invalid paperport protocol
Unsupported paperport
command
Unknown page supervisor
state
Paperport framing error
Paperport overrun error
Possible repair actions
1. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
"High
installation. Go to
capacity input tray (HCIT)
pick arm bracket
assembly removal" on
page
4-131.
2. Replace the RFID UHF
option.
Note: There can be no other
connectivity options installed
on printers that have the RFID
UHF option installed. If any
connectivity option is installed
(other than the RFID interface
card), a 985.xx error will occur
Close the rear door on all
output options.
Replace the system card
assembly.
Go to
"System card
assembly removal" on
page
4-76.
Replace the system card
assembly.
"System card
Go to
assembly removal" on
page
4-76.
Replace the system card
assembly.
Go to
"System card
assembly removal" on
page
4-76.
Replace the system card
assembly.
"System card
Go to
assembly removal" on
page
4-76.
Replace the system card
assembly.
Go to
"System card
assembly removal" on
page
4-76.
Replace the system card
assembly.
Go to
"System card
assembly removal" on
page
4-76.
Diagnostic information
2-117

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5230n5530dn5350dn

Table of Contents