Sensor (pass through) service check
Step
1
1. Enter the diagnostic mode
2. Select Input tray tests
3. Select Sensor test
4. Select the appropriate tray number
5. Observe the line item "pass through" for the appropriate
media tray
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
2
Check the above sensor for proper connection.
Is the above sensor connected properly?
Sensor (envelope feeder empty) service check
Step
1
1. Enter the diagnostic mode
2. Select Input tray tests
3. Select Sensor test
4. Select Envelope feeder
5. Observe the line item "empty"
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
2
Check the above sensor for proper connection.
Is the above sensor connected properly?
Sensor (input) late jam service check.
Use this procedure for the following jams:
• 200.07
• 241.06
• 241.15
• 250.06
• 250.11
• 260.14
Check
Check
• 230.04
• 230.06
• 214.10
• 241.11
• 241.16
• 241.18
• 250.07
• 250.08
• 260.07
• 260.10
• 260.15
• 260.16
Yes
The sensor is
Go to step 2.
working properly
Replace the
Replace the
sensor (pass
connection.
through).
"250-sheet
Go to
controller card
assembly
removal" on
page
4-107.
Yes
The sensor is
Go to step 2.
working properly
Replace the
Replace the
envelope feeder.
connection.
• 237.00
• 239.11
• 241.12
• 241.14
• 242.09
• 250.03
• 250.09
• 250.10
• 260.11
• 260.12
Diagnostic information
No
No
2-123