System Card Assembly Removal - Dell 5230dn Mono Laser Printer Service Manual

System card assembly removal

WARNING: When replacing any of the following components:
• Operator panel assembly (5230n/dn, 5350dn, and 5530dn)
• NVM card assembly (T656 only)
• System card assembly (All models)
Only replace one component at a time. Replace the required component and perform a POR before replacing
a second component listed above. If this procedure is not followed, the printer will be rendered inoperable.
Never replace two or more of the components listed above without a POR after installing each one or the
printer will be rendered inoperable.
Never install and remove components listed above as a method of troubleshooting components. Once a
component has been installed in a machine, it can not be used in another machine. It must be returned to the
manufacturer.
1. Remove the side cover, left. Go to
left removal (5350dn, 5530dn, and T656)" on page
2. Remove the six screws (A) securing the metal shield to the machine.
3. Slide the metal shield in the direction of the arrow.
4-76
Service Manual
CAUTION
This product contains a lithium battery. THERE IS A RISK OF EXPLOSION IF THE BATTERY
IS REPLACED BY AN INCORRECT TYPE. Discard used batteries according to the battery
manufacturer's instructions and local regulations.
"Side cover, right removal (5230n/dn)" on page 4-67
A
4-67.
or "Side cover,