Bin Mailbox Sensor (Pass Through) Removal - Dell 5230dn Mono Laser Printer Service Manual

Service manual
Hide thumbs Also See for 5230dn Mono Laser Printer:
Table of Contents

Advertisement

5-bin mailbox sensor (pass through) removal

1. Remove the 5-bin mailbox left outer cover. Go to
2. If the lower pass through sensor needs to be removed, first remove the 5-bin mailbox rear door assembly.
"5-bin mailbox rear door assembly removal" on page
Go to
3. Lift up the deflector gate above the sensor (pass through) and using a flat-blade screwdriver, release the
tabs securing the sensor.
4. Disconnect the appropriate harness from the controller card (J11) for the upper sensor (pass through) and
(J5) for the lower sensor (pass through).
Note: The use of a spring hook facilitates the unrouting of the cables. Remove the two screws (A) and lift the
left frame assembly to ease removal of the lower sensor (pass through) harness.
"5-bin mailbox left outer cover removal" on page
4-85.
A
4-86.
4-91
Repair Information

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5230n5530dn5350dn

Table of Contents