Step
9
Perform a print test.
Does the problem remain?
Sensor (fuser output) static jam service check
Use this procedure for the following jams:
• 202.06
• 202.63
Step
1
Check the media path for partially fed or jammed media.
Is the media path free from partially fed or jammed media?
2
Check the sensor (fuser output) for proper operation.
1. Enter the diagnostic mode
2. Select Base sensor test
3. Observe the line item "input"
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
3
Check the above sensor for proper connection.
Is the above sensor connected properly?
4
Perform a print test.
Does the problem remain?
2-132
Service Manual
Check
• 202.13
• 202.31
• 202.81
• 202.88
Check
Yes
Contact next
Problem solved.
highest level of
tech support.
• 202.38
• 202.56
Yes
Go to step 2.
Remove any pre-
staged or jammed
media.
Go to step 4.
Go to step 3.
Replace the fuser
Replace the
unit assembly.
connection.
Go to
"Fuser unit
assembly
removal" on
page
4-22.
Contact next
Problem solved.
highest level of
tech support.
No
No