Dell 5230dn Mono Laser Printer Service Manual page 327

Service manual
Hide thumbs Also See for 5230dn Mono Laser Printer:
Table of Contents

Advertisement

6. Remove the two screws (B) securing the alignment assembly to the machine.
B
Note: The adjuster screw (C) requires a hex wrench to loosen and tighten.
Note: The adjuster screw (C) can be accessed through the hole (D) in the system card.
7. Completely loosen the adjuster screw (C) securing the alignment assembly to the machine.
8. Remove the alignment assembly.
D
C
Replacement Warning: When replacing the alignment assembly, ensure that the media skew is properly
"Alignment assembly adjustment" on
adjusted using the adjuster screw (C) or jamming will occur. Go to
page
4-4.
4-9
Repair Information

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5230n5530dn5350dn

Table of Contents