Utility Settings; Setting Up The Oscilloscope's Lan Connection - Agilent Technologies 4000 X-Series User Manual

20

Utility Settings

When an I/O interface is installed, remote control over that interface is
always enabled. Also, the oscilloscope can be controlled via multiple I/O
interfaces (for example, USB and LAN) at the same time.
See Also
•
•
• The oscilloscope's Programmer's Guide.
•

Setting up the Oscilloscope's LAN Connection

Using the rear panel LAN port, you can place the oscilloscope on the
network and set up its LAN connection. Once that is done, you can set up
and use network printers or use the oscilloscope's web interface or
remotely control the oscilloscope via the LAN interface.
The oscilloscope supports methods for automated LAN configuration or
manual LAN configuration (see
page 331). It is also possible to set up a point- to- point LAN connection
between a PC and the oscilloscope (see
Connection to a PC"
Once the oscilloscope is set up on the network, you can use the
oscilloscope's web page to view or change its network configuration and
access additional settings (like the network password). See
"Web Interface," starting on page 349.
When you connect the oscilloscope to a LAN it is a good practice to limit access to the
N O T E
oscilloscope by setting a password. By default, the oscilloscope is not password protected.
See
330
• LAN — When connected to a LAN, you can use the LAN Settings and
LAN Reset softkeys to configure the LAN interface. See
Oscilloscope's LAN Connection"
• There are no configuration settings for the USB interface.
Chapter 21, "Web Interface," starting on page 349 (when the
oscilloscope is connected to a LAN).
"Remote Programming via the Web Interface"
"Remote Programming with Agilent IO Libraries"
on page 332).
"Setting a Password"
on page 330.
"To establish a LAN connection"
"Stand- alone (Point- to- Point)
on page 363 to set a password.
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
"Setting up the
on page 355
on page 356
on
Chapter 21,