Config: Remote; Config: Remote Local; Config: Remote Serial - Comtech EF Data CDM-Qx Installation And Operation Manual

CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier®
Front Panel Operation
5.4.1

CONFIG: Remote

Remote Control Entry: Local
Serial Ethernet
Select Local, Serial, or Ethernet using the
5.4.1.1 CONFIG: Remote
If CONFIG: Remote
is still possible.
5.4.1.2 CONFIG: Remote
Remote Serial Config:
Interface Baudrate (◄ ►,ENT)
Select Interface or Baudrate using the
CONFIG: Remote
M&C Serial Interface: RS232
RS485-2W RS485-4W (◄ ►,ENT
From the Interface submenu, the user is further prompted to enter the bus address. Select
RS232, RS485-2W (2-wire), or RS485-4W (4-wire) using the ◄ ► arrow keys, then press
.
ENTER
CONFIG: Remote
In RS-232 Mode, Serial Bus
Base Address is fixed @ 0000
Note that the bus base address in RS-232 mode is fixed and cannot be edited.
CONFIG: Remote
Edit RS-485 Serial Bus Base
Address: 0245
If either RS-485 mode is selected, edit the RS-485 bus address of this unit by first
selecting the digit to be edited using the
digit to be edited by using the
9999. Press ENTER when done.
CONFIG: Remote
M&C Serial Bus Baud Rate:
19200 Baud
Using the
the M&C computer. Values of 2400, 4800, 9600, 19200, 38400, and 57600 baud are
(◄ ►,ENT)
Local
Local is selected, remote control is disabled, although remote monitoring
Serial
◄ ►
Serial
Serial
Serial
(◄ ►,▲▼,ENT)
Serial
(▲ ▼,ENT)
arrow keys, edit the baudrate of the remote control bus connected locally to
5–10
arrow keys, then press
◄ ►
arrow keys, then press
Interface
Interface RS232
Interface RS485(-2W, -4W)
arrow keys, then change the value of the
arrow keys. The valid range of addresses is from 1 to
Baudrate
Revision 7
MN/CDMQX.IOM
.
ENTER
.
ENTER