Configuring Acs For Wds Authentication; Configuring Cisco Wlse Rogue Scanning - Dell PowerConnect W-Airwave User Manual

4. Go to the Security > Server Manager page.
5. Enter the IP address and Shared Secret for the ACS server and select Apply.
6. Go to the Wireless Services > WDS > Server Group page.
7. Enter the WDS Group of AP.
8. Select the ACS server in the Priority 1 drop-down menu and select Apply.

Configuring ACS for WDS Authentication

ACS authenticates all components of the WDS and must be configured first. Perform these steps to make this
configuration.
1. Login to the ACS.
2. Go to the System Configuration > ACS Certificate Setup page.
3. Install a New Certificate by selecting the Install New Certificate button, or skip to the next step if the
certificate was previously installed.
4. Select User Setup in the left frame.
5. Enter the Username that will be used to authenticate into the WDS and select Add/Edit.
6. Enter the Password that will be used to authenticate into the WDS and select Submit.
7. Go to the Network Configuration > Add AAA Client page.
8. Add AP Hostname, AP IP Address, and Community String (for the key).
9. Enter the Password that will be used to authenticate into the WDS and select Submit.
For additional and more general information about ACS, refer to

Configuring Cisco WLSE Rogue Scanning

The AMP Setup > WLSE page allows AMP to integrate with the Cisco Wireless LAN Solution Engine (WLSE).
AMP can discover APs and gather rogue scanning data from the Cisco WLSE.
Figure 31
Figure 31 AMP Setup > WLSE > Add WLSE Page Illustration
Perform the following steps for optional configuration of AMP for support of Cisco WLSE rogue scanning.
1. To add a Cisco WLSE server to AMP, navigate to the AMP Setup > WLSE page and select Add. Complete
the fields in this page.
Table 34 AMP Setup > WLSE Fields and Default Values
Setting
Hostname/IP Address
Protocol
Dell PowerConnect W-AirWave | User Guide
illustrates and itemizes the AMP settings for communication that is enabled between AMP and WLSE.
Table 34 describes the settings and default values.
Default
None
HTTP
"Configuring ACS Servers" on
Description
Designates the IP address or DNS Hostname for the WLSE server, which must
already be configured on the Cisco WLSE server.
Specifies the protocol to be used when polling the WLSE.
page 62.
Configuring AMP | 61