Configuring Radius Authentication And Authorization - Dell PowerConnect W-Airwave User Manual

Enter AMP in the service column and https in the protocol column.

Select Save.

5. Edit the existing groups or users in TACACS to use the "AMP service" and define a role for the group or user.
The role defined on the Group Setup page in ACS must match the exact name of the role defined on the

AMP Setup > Roles page.
The defined role should use the following format:

follows:
As with routers and switches, AWMS does not need to know usernames.
6. AWMS also needs to be configured as an AAA client.
On the Network Configuration page, select Add Entry.

Enter the IP address of AWMS as the AAA Client IP Address.

The secret should be the same value that was entered on the AMP Setup > TACACS+ page.

7. Select TACACS+ (Cisco IOS) in the Authenticate Using dropdown menu and select submit + restart.
NOTE: AWMS checks the local username and password store before checking with the TACACS+ server. If the user is found
locally, the local password and local role apply. When using TACAS+, it is not necessary or recommended to define users on the
AWMS server. The only recommended user is the backup administrator, in the event that the TACAS+ server goes down.
What Next?
Go to additional tabs in the AMP Setup section to continue additional setup configurations.

Complete the required configurations in this chapter before proceeding. Dell support remains available to you for

any phase of AWMS installation.

Configuring RADIUS Authentication and Authorization

For RADIUS capability, you must configure the IP/Hostname of the RADIUS server, the TCP port, and the
server shared secret. Perform these steps to configuration RADIUS authentication:
1. Go to the AMP Setup > Authentication page. This page displays current status of RADIUS.
illustrates this page.
54 | Configuring AWMS
role=DormMonitoring
role=<name_of_AMP_role>
Dell PowerConnect W AirWave 7.2 | User Guide
. One example is as
Figure 25