Using Dell Ulnm With Vmware Esx 4.0; Step 1 (Access); Step 2 (Configuration) - Dell PowerEdge UPS 500T User Manual

2.3. USING DELL ULNM WITH VMWARE ESX 4.0

After Dell ULNM installation, follow these 3 steps to use Dell ULNM or refer to the Dell ULNM User
guide.

2.3.1. STEP 1 (ACCESS)

Remote access (for VMware ESX 4.0)

From a remote machine, you can type the following URL in a Web browser
https://<name or IP address of Server hosting DELL ULNM>:4680/
or
http://<name or IP address of Server hosting DELL ULNM>:4679/

In SSL mode, accept the certificate (by clicking on Yes)
(enter admin as Login / admin as Password and click on the Login button)

2.3.2. STEP 2 (CONFIGURATION)

When started, the application automatically performs a Quick scan.

Using the Quick scan operation, you will discover:
=>Serial line connected UPSs (RS232 or USB)
The discovered UPS connected through (RS232 or USB) is automatically assigned as the
Power source (the Status icon is Green
=> Networked UPSs through broadcast within a few seconds (Dell Network Management
Card H910P)
The discovered UPS connected through (Network) are not automatically assigned as the
Power source (You have to select the node and click on the button Set as Power Source the
icon becomes Green
Dell ULNM – User guide extension - VMWare ESX Server
VMware is a registered trademark of VMware, Inc.
rev0.01
USER'S GUIDE EXTENSION FOR VMWARE ESX 4.0 VIRTUAL ARCHITECTURE
)
)
Dell UPS Local Node Manager
Dellups.com
7