Memory Scan (Memory Mode); D Memory Scan - Icom IC-i7410 Instruction Manual

8
SCANS

■ Memory scan (Memory mode)

D Memory scan

A Memory scan searches for signals through Memory
channels 1 to 99.
Blank (unprogrammed) channels are skipped.
NOTE: To start a Memory scan, two or more Mem-
ory channels must be programmed. (p. 70)
q Push [VFO/MEMO] to select the Memory mode.
w Push [MENU] to display the "M2" screen (Menu 2).
e Push [SCAN](F-1) to display the "SCAN" screen.
r Rotate the [RF/SQL] control to set the squelch to
open or closed.
• The scan performance differs, depending on the squelch
setting when the scan was started. See page 76 for de-
tails.
• If the [RF/SQL] control function is set to "AUTO," the
squelch is always open in the SSB, CW and RTTY
modes. (pp. 2, 32, 86)
t Push [MEM](F-1) to start or cancel the Memory
scan.
• The MHz and kHz decimal points, and "MEMO SCAN"
blink while scanning.
• Rotating [DIAL] also cancels the scan.
79
[SCAN]/[MEM] [VFO/MEMO]
[RF/SQL] [MENU]
SCAN ∂ F
M E M S E L SPAN
∂ F
SCAN MEMO SCAN
M E M S E L SPAN
∂ F
While Memory scanning
: 1 0 k
±
S E T
S E T