D Select Memory Scan; D Setting/Cancelling Select Memory Channels - Icom IC-i7410 Instruction Manual

D Select Memory scan

Select Memory scan searches for signals through
Memory channels programmed as "Sel" (Select).
NOTE: To start a Select Memory scan, two or more
Memory channels must be designated as Select
Memory channels.
q Start a Memory scan.
• Follow steps q through t on the previous page.
w While scanning, push [SEL](F-3) to switch the scan
function between a Memory scan and a Select
Memory scan.
• "SEL-MEMO SCAN" blinks while Select Memory scan-
ning.
e Push [MEM](F-1) to cancel the scan.
• Rotating [DIAL] also cancels the scan.

D Setting/Cancelling Select Memory channels

All Memory channels can be set as Select Memory
channels, except for the Scan Edge channels.
➥ When the "SCAN" screen is displayed, push [SEL]
(F-3), or when the "MEM" screen (Memory Menu)
is displayed, push [SEL](F-5) to set or cancel the
displayed Memory channel as a Select Memory
channel.
• "SEL" appears when the channel is set as a Select
Memory channel.
• An error beep sounds when the displayed Memory
channel is a blank channel.
• Holding down [SEL](F-3) or [SEL](F-5) for 1 second dis-
plays "SEL ALL Clear?." Hold down [YES](F-4) to clear
all Select Memory channel settings.
MEMO SCAN
SCAN
M E M S E L SPAN
∂ F
SEL−MEMO
SCAN
M E M S E L SPAN
∂ F
While Select Memory scanning
SCAN
∂ F
M E M S E L SPAN
∂ F
"SCAN" screen
14.19500
MEM
E D T (
"MEM" screen (Memory Menu)
8
SCANS
S E T
SCAN
S E T
Appears
: 1 0 k
±
S E T
USB
) S E L
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
80