Programmed Scan/Fine Programmed Scan (Vfo Mode); D About The Fine Programmed Scan - Icom IC-i7410 Instruction Manual

■ Programmed scan/Fine programmed scan (VFO mode)

A programmed scan searches for signals between
Program Scan Edge channels "P1" and "P2."
Before starting the programmed scan, scan edges
must be programmed into these channels.
Refer to "■ Memory Channel programming" to pro-
gram Program Scan Edge channels. (p. 70)
If the same frequencies are programmed into the
Program Scan Edge channels, the programmed
scan will not start.
q Push [VFO/MEMO] to select the VFO mode.
w Push a mode switch to select the desired operating
mode (p. ).
• The operating mode can also be changed while scan-
ning.
e Push [TS] one or more times to select a tuning step.
(p. 27)
• The tuning step can also be changed while scanning.
r Push [MENU] once or twice to display the "M2"
screen (Menu 2).
t Push [SCAN](F-1) to display the "SCAN" screen.
y Rotate the [RF/SQL] control to set the squelch to
open or closed.
• The scan performance differs, depending on the squelch
setting when the scan was started. See page 76 for de-
tails.
• If the [RF/SQL] control function is set to "AUTO," the
squelch is always open in the SSB, CW and RTTY
modes. (pp. 2, 32, 86)
u Push [PRO](F-1) to start or cancel the programmed
scan.
• The MHz and kHz decimal points, and "PROG SCAN"
blink while scanning.
• Rotating [DIAL] also cancels the scan.

D About the Fine programmed scan

When a signal is received during Fine programmed
scan, the scanning tuning step is temporarily set to
10 Hz and the scan speed decreases.
q Start the programmed scan.
• Follow steps q through u as described above.
w While scanning, push [FIN](F-3) to switch the scan
function between a programmed scan and a Fine
programmed scan.
• "F-PROG SCAN" blinks while Fine programmed scan-
ning.
e Push [PRO](F-1) to cancel the scan.
• Rotating [DIAL] also cancels the scan.
[SCAN]/[PRO] [VFO/MEMO] [TS]
[RF/SQL] [MENU] Mode switches
SCAN
P R O F I N SPAN
∂ F
PROG SCAN
SCAN
P R O F I N SPAN
∂ F
While Programmed scanning
PROG SCAN
SCAN
P R O F I N SPAN
∂ F
F−PROG SCAN
SCAN
P R O F I N SPAN
∂ F
While Fine programmed scanning
8
SCANS
: 1 0 k
∂ F ±
S E T
S E T
S E T
S E T
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
78