Additional Drive Enclosure Installation - Fujitsu Eternus DX60 User Manual

Chapter 5 Installing Optional Products
> 5.2 Drive Enclosure Installation
9
5.2.4

Additional Drive Enclosure Installation

This section describes how to install a drive enclosure for the ETERNUS DX60/DX80.
Procedure
1
2
3
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
DE_No. label is attached to the base device.
Check the settings of the AUTO POWER switch and the MODE_SEL switch.
• AUTO POWER switch
Check that the AUTO POWER switch is set to the OFF position. Do not change to ON.
• MODEL_SEL switch
Check that the MODEL_SEL switch is set to the ON position. Do not change to OFF.
Drive enclosure
AUTO POWER
switch
MODE_SEL
switch
First check that all the components of the ETERNUS DX60/DX80 are in normal
status, using the Storage System Status screen of GUI.
Wear a wrist strap.
For how to wear a wrist strap, refer to
Click [Add Drive Enclosure] under the [Hardware Maintenance] menu on the
[Maintenance] tab in the GUI screen.
The [Add Drive Enclosure] initial screen appears.
"2.2.4 Wearing the Wrist Strap" (page
170
End of procedure
61).
Copyright 2009 FUJITSU LIMITED