Fujitsu Eternus DX60 User Manual page 72

Chapter 3 Installation
> 3.2 Rack Installation
Procedure
1
2
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Refer to "ETERNUS DX60/DX80 Disk storage system Package Contents" to
confirm there are no missing parts for the rack mount kit.
"ETERNUS DX60/DX80 Disk storage system Package Contents"
Refer
Adjust the rack rail (bracket L (for left side) and bracket R (for right side)) sizes to
fit the rack.
Reposition the M4 screws to adjust the length of the rack rails (brackets) to match the
distance between the front and rear rack pillars. Leave the M4 screws slightly unscrewed,
as the bracket must be attached to the rack before they can be completely tightened.
Bracket L (for left side)
"L" is stamped on the inner
side of the left rack rail.
[Left]
(Front rack pillars)
[Right]
(Rear rack pillars)
Loosen the M4 screws,
and adjust the rack rails to
the depth of the rack.
Bracket R (for right side)
"R" is stamped on the inner
side of the right rack rail.
72
Copyright 2009 FUJITSU LIMITED