Eternus Dx60/Dx80 Setup; Preparation - Fujitsu Eternus DX60 User Manual

Chapter 4 Setup
>

4.3 ETERNUS DX60/DX80 Setup

4.3 ETERNUS DX60/DX80 Setup
This section explains how to setup the ETERNUS DX60/DX80 using a PC.
4.3.1

Preparation

Prepare the following before setting up the ETERNUS DX60/DX80.
Filling in the Network Settings Label
Fill in the IP address and subnet mask fields on the Network Settings label and attach it on rear
upper central label plate.
Label holder
Figure 4.7
The IP address for the PC used by the maintenance engineer during maintenance is also
required. Acquire the IP address and note it on the Network Settings label.
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Network Settings label
Network Setting
IP address of Disk Array
Subnet Mask
IP address of FST port
IP address of REMCS port
Plate
Tag
Pull out the plate while holding the tag.
Network Settings label
113
: . . .
: . . .
: . . .
: . . .
Copyright 2009 FUJITSU LIMITED