Fujitsu Eternus DX60 User Manual page 77

Chapter 3 Installation
> 3.2 Rack Installation
5
5-1
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Attach the blank panel to the front side of the rack.
blank panel
The should be attached at the same height as the AC outlet box.
Attach the M5 cage nuts or M5 rack nuts to the front rack pillar.
•
•
- Attachment positions
On either side, insert two M5 cage nuts or M5 rack nuts in the 2nd holes above the
blank panel base line.
[Left]
M5 cage nut or
M5 rack nut
1U
2nd position
- Attachment procedure
M5 cage nut
Clip the cage nut tabs into the desired
hole from the inside.
Side view
M5 cage nut
Rack pillar (square)
Use the M5 cage nuts if the rack pillar holes are square.
Use the M5 rack nuts if the rack pillar holes are round.
(Rear rack pillars)
[Right]
Blank panel
Base line of
AC outlet box
M5 rack nut
Clip the rack nut over the desired
hole from the side.
77
M5 cage nut or
M5 rack nut
2nd position
M5 Rack nut
Rack pillar (round)
Copyright 2009 FUJITSU LIMITED