Fujitsu Eternus DX60 User Manual page 70

Chapter 3 Installation
> 3.2 Rack Installation
4
5
6
7
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Tighten the M4 screws of the rack rails (brackets) that were slightly unscrewed in
Step 2.
Remove the front cover of the controller enclosure.
Refer to "2.2.3 Attaching and Removing the Front Cover" (page 58)
remove the front cover.
Install the controller enclosure in the rack.
CAUTION
•
•
Fix the controller enclosure in the rack.
Use the two thumb screws at the front of the controller enclosure to fasten it in the rack.
Thumb screw
Do
When installing or removing the controller enclosure to or
from the rack, make sure to have the right and left sides and
the bottom of the controller enclosure by two or more people.
Failure to do so may cause injury.
Two pieces of tape are attached to the top of the controller
enclosure. Make sure that this tape does not come off.
Tape
(Rear rack pillars)
70
for procedure to
Copyright 2009 FUJITSU LIMITED