Chapter 5 Installing Optional Products
>
5.2 Drive Enclosure Installation
5.2.2
Installable Drive Enclosures
Refer to
At time of purchase, the drive enclosure model may be different from those described.
The latest manual is available via the following web-site, and should be referred to as necessary.
http://www.fujitsu.com/global/services/computing/storage/eternus/products/diskstorage/dx60-
dx80/
5.2.3
Drive Enclosure Rack Mounting Procedure
This section describes how to mount a drive enclosure in a rack.
IMPORTANT
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
"A.2.2 Drive Enclosures" (page 192)
Do
CAUTION
•
If drive enclosures are installed in a way other than by the methods
described herein, damage to the device and/or failure or electrical
shock may occur.
•
Make sure to install the drive enclosures in order, above the
controller enclosure.
•
Take care not to knock or drop the drive enclosure on the rack when
installing it.
•
When no other components are to be installed in a drive slot, install
the dummy disk units provided with the rack.
•
When expanding multiple drive enclosures, by installing them into the
rack or expanding settings via GUI, make sure to expand one by one.
•
Do not install the miniSAS cable (for drive enclosures) or power cord
when installing the drive enclosure in the rack. Connect them in
and
Step 6
•
Install the disk after expanding the drive enclosure.
for a list of drive enclosures that may be installed.
in
"5.2.4 Additional Drive Enclosure
166
Step 5
Installation".
Copyright 2009 FUJITSU LIMITED