Configuration Wizard - Fujitsu Eternus DX60 User Manual

Chapter 4 Setup
> 4.3 ETERNUS DX60/DX80 Setup
6-3
4.3.3

Configuration Wizard

Perform the necessary settings for the device operation using the Configuration Wizard of the
setting\maintenance program.
Perform the settings in the following order.
• Create RAID Group
• Create Volume
• Define Host
• Configure Affinity Group
• Define LUN Mapping
IMPORTANT
For setting-related details, refer to the "ETERNUS DX60/DX80 Web GUI User Guide". Also refer
to the "ETERNUS Disk storage systems Server Connection Guide" as required.
Refer
Procedure
1
1-1
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Start the Web browser, and logon again with the new IP address to perform the config-
uration settings of the ETERNUS DX60/DX80 using Configuration Wizard.
Perform "Set Port Parameters" before starting the Configuration Wizard.
When using the Host Affinity functions, make sure to "Enable" the Host
Affinity setting of the port.
Refer to "4.3.5 Port Parameters Setup" (page 133)
parameter settings.
Refer to "1.3.7 Security Functions" (page 41)
Affinity functions.
"ETERNUS DX60/DX80 Web GUI User Guide
"ETERNUS Disk storage systems Server Connection Guide (Fibre Channel)"
"ETERNUS Disk storage systems Server Connection Guide (iSCSI)"
"ETERNUS Disk storage systems Server Connection Guide (SAS)"
Start Configuration Wizard.
Click the [Configuration Wizard] button on the [Easy Setup] tab in GUI.
The [Configuration Wizard] screen appears.
120
End of procedure
for details about the port
for details about the Host
Copyright 2009 FUJITSU LIMITED