Fujitsu Eternus DX60 User Manual page 79

Chapter 3 Installation
> 3.2 Rack Installation
3
4
4-1
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
• Attachment procedure
M5 cage nut
Clip the cage nut tabs into the desired
hole from the inside.
Side view
M5 cage nut
Rack pillar (square)
Mount the AC outlet box in the rack.
Fasten it to the prepared holes in the pillars with eight M5 screws.
M5 screws
M5 screws
Attach the blank panel to the rack front.
Mount it in the same position as the AC outlet box.
Attach the M5 cage nuts or M5 rack nuts to the front rack pillar.
•
•
- Attachment positions
On either side, insert four M5 cage nuts or M5 rack nuts in the 2nd and 5th holes
above the blank panel base line.
M5 cage nut or
[Left]
M5 rack nut
5th position
2U
2nd position
M5 rack nut
Clip the rack nut over the desired
hole from the side.
M5 Rack nut
Rack pillar (round)
(Rear rack pillars)
Use the M5 cage nuts if the rack pillar holes are square.
Use the M5 rack nuts if the rack pillar holes are round.
(Rear rack pillars)
[Right]
Blank panel
Base line of
AC outlet box
79
M5 cage nut or
M5 rack nut
5th position
2nd position
Copyright 2009 FUJITSU LIMITED