Fujitsu Eternus DX60 User Manual page 85

Chapter 4 Setup
> 4.2 Cable Connection
LAN cable connection procedure
The following explains how to connect the LAN cable.
IMPORTANT
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Do
CAUTION
• Make sure to wear a wrist strap before starting each operation, as
failure to discharge static electricity may cause a device failure.
Do not remove it until the operation is complete.
• When connecting external (signal, power, etc.) cables, avoid pulling
them as it may cause damage.
Do Not
• Do not bend the cable too much or bind it up. Doing so may cause
device damage or failure.
Do not bend square
When connecting LAN cables, check the connector orientation and then
firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the
connector.
This section describes dual controller model as an example. Note that there
is only controller 0 (CM#0) for single controller model.
90
Do not bind up
85
Copyright 2009 FUJITSU LIMITED