Fujitsu Eternus DX60 User Manual page 45

Chapter 2 Hardware
> 2.1 Components
2.1.1.2 Front view (without front cover)
Figure 2.2
Disk slot numbers
Figure 2.3
Figure 2.3
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
DISK STATUS LED
Glows or blinks green when disks
are operating normally.
Glows orange when a disk has failed.
Disk
Up to 12 disks can be installed in the ETERNUS DX60/DX80.
AUTO POWER Switch
Enables the AC Auto-Link Mode
(This function automatically turns on the linked
device once AC power is supplied).
This switch is set to "OFF" as the factory setting.
MODE_SEL Switch
Enables the device power to be turned on via
power linkage
This switch is set to "ON" as the factory setting
and should not be set to "OFF".
IP RESET Switch
For dual controller model, click once to switch
the Master CM LAN port from the current controller
to the other controller.
Click twice in succession within a two second
interval to revert the IP addresses to their
factory settings.
Front view of controller enclosure (without front cover)
shows the slot number of each disk.
Slot#8 Slot#9 Slot#10
Slot#4 Slot#5 Slot#6
Slot#0 Slot#1 Slot#2
Disk slot numbers (controller enclosure)
Slot#11
Slot#7
Slot#3
45
Copyright 2009 FUJITSU LIMITED