Minisas Cable Connection (For Sas) - Fujitsu Eternus DX60 User Manual

Chapter 4 Setup
> 4.2 Cable Connection
2
4.2.4

MiniSAS Cable Connection (For SAS)

Connect the ETERNUS DX60/DX80 and the server with miniSAS cables.
User must prepare their own miniSAS cables (ETERNUS DX60/DX80 connector: SFF8088).
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
If only one iSCSI port is to be used, it should be port 0 on each CM.
CAUTION
•
Connect the LAN cables to the server or switching hub.
Connect the other end of the LAN cable to the server's LAN card or iSCSI HBA, or to the
switching hub. For switching hub connection details, refer to the documentation for the
switching hub being connected to.
Do
CAUTION
• Be sure to wear a wrist strap or discharge static electricity by
touching the metal frame of the ETERNUS DX60/DX80 before
starting each operation, as failure to discharge static electricity may
cause device failure.
• When connecting external (signal, power, etc.) cables, avoid pulling
them as it may cause device damage.
Do Not
• Do not bend the cable too much or bind it up. Doing so may cause a
device damage or failure.
Do not bend square
Do
When connecting the LAN cables, position them so that they
will not obstruct replacement of the power supply unit or
controllers by the maintenance engineer.
90
Do not bind up
92
End of procedure
Copyright 2009 FUJITSU LIMITED