Fujitsu Eternus DX60 User Manual page 74

Chapter 3 Installation
> 3.2 Rack Installation
6
7
8
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Install the drive enclosure in the rack.
CAUTION
•
•
Fasten the drive enclosure in the rack.
Use the two thumb screws at the front of the drive enclosure to fasten it in the rack.
Thumb screw
Finish by replacing the front cover.
Refer to "2.2.3 Attaching and Removing the Front Cover" (page 58)
replacement procedure.
Do
When installing or removing the drive enclosure to or from the
rack, make sure to have the right and left sides and the
bottom of the drive enclosure by two or more people. Failure
to do so may cause injury.
Two pieces of conductive tape are attached to the top of the
drive enclosure. Make sure that this tape does not come off.
Tape
(Rear rack pillars)
74
for the front cover
End of procedure
Copyright 2009 FUJITSU LIMITED