Fujitsu Eternus DX60 User Manual page 69

Chapter 3 Installation
> 3.2 Rack Installation
3
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Bracket L (for left side)
"L" is stamped on the inner
side of the left rack rail.
[Left]
(Front rack pillars)
[Right]
Attach the rack rails (brackets) to the rack.
• When the holes in the rack pillars are square, use the screw
holders to attach.
• Make sure to attach the rack rails (brackets) and rack pillars so
that they fit exactly together without any space between them.
Bracket L
Screw holders
M5 screws
(Front rack pillars)
M5 screws
The four M5 screw positions for the rack rails (brackets) are determined relatively to the
base line of controller enclosure.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
[Left]
3rd position
2U
Controller enclosure
(M5 screws)
1st position
(M5 screws)
Base line of
controller enclosure
Rack rails
(Brackets)
(Rear rack pillars)
Loosen the M4 screws,
and adjust the rack rails to
the depth of the rack.
Bracket R (for right side)
"R" is stamped on the inner
side of the right rack rail.
Screw holders
(Rear rack pillars)
Bracket R
Screw holders
[Right]
3rd position
(M5 screws)
1st position
(M5 screws)
69
M5 screws
M5 screws
Screw holders
Copyright 2009 FUJITSU LIMITED