Fujitsu Eternus DX60 User Manual page 73

Chapter 3 Installation
> 3.2 Rack Installation
3
4
5
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Attach the rack rails (brackets) to the rack.
• If the rack pillars have square (approx. 9mm) holes, screw
holders will need to be used when attaching the rack rails
(brackets).
• Make sure to attach the rack rails (brackets) and rack pillars so
that they fit exactly together without any space between them.
Bracket L
Screw holders
M5 screws
(Front rack pillars)
M5 screws
The four M5 screw positions for the rack rails (brackets) are determined relative to the
drive enclosure base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
[Left]
3rd position
2U
Drive enclosure
(M5 screws)
1st position
(M5 screws)
Base line of
drive enclosure
Rack rails
(Brackets)
Tighten the M4 screws of the rack rails (brackets) that were slightly unscrewed in
Step 2.
First remove the front cover.
Refer to "2.2.3 Attaching and Removing the Front Cover" (page 58)
remove the front cover.
Screw holders
(Rear rack pillars)
Bracket R
Screw holders
[Right]
3rd position
(M5 screws)
1st position
(M5 screws)
73
M5 screws
M5 screws
Screw holders
for procedure to
Copyright 2009 FUJITSU LIMITED