Fujitsu Eternus DX60 User Manual page 172

Chapter 5 Installing Optional Products
> 5.2 Drive Enclosure Installation
7
8
9
10
11
12
13
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Check that the drive enclosure's POWER LED and READY LED are on.
Click the [Next >] button.
The drive enclosure recognition process is performed. When the process completes, the
drive enclosure's AUTO POWER switch check procedure screen is displayed.
Check the drive enclosure's AUTO POWER switch is OFF, and click the [Next >]
button.
Figure 5.4 [Add Drive Enclosure] - Workflow Sequence screen 2
The expansion completion screen is displayed.
On the Storage System Status screen, check that the added drive enclosures
have been recognized.
Install the disks.
Refer to "5.1.4 Additional Disk Installation Procedure" (page 161)
procedure.
Remove the wrist strap.
Finish by replacing the front cover.
Refer to "2.2.3 Attaching and Removing the Front Cover" (page 58)
procedure.
Drive enclosure
172
for the appropriate
for the appropriate
End of procedure
Copyright 2009 FUJITSU LIMITED