Fujitsu Eternus DX60 User Manual page 96

Chapter 4 Setup
> 4.2 Cable Connection
Procedure
1
1-1
1-2
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Connect the controller enclosure to the drive enclosure with the miniSAS cable.
Connect the SAS (OUT) port at controller 0 (CM#0) of controller enclosure, to the SAS
(IN) port at expander 0 (EXP#0) of the drive enclosure 1 with the miniSAS cable.
(1) Connect the plug to be connected to SAS (OUT) port, to the SAS (OUT) port of the
controller 0 (CM#0).
Remove the port cover from the SAS (OUT) port before inserting the plug.
Controller
enclosure
(2) Connect the plug to be connected to SAS (IN) port, to the SAS (IN) port of the
expander 0 (EXP#0).
Drive
enclosure 1
For dual controller model, connect the SAS (OUT) port at controller 1 (CM#1) of
controller enclosure, to the SAS (IN) port at expander 1 (EXP#1) of the drive enclosure
1 with the miniSAS cable.
Connect the miniSAS cable in the same way as Step
96
1-1.
Copyright 2009 FUJITSU LIMITED