Fujitsu Eternus DX60 User Manual page 93

Chapter 4 Setup
> 4.2 Cable Connection
MiniSAS cable connection procedure
The following explains how to connect the miniSAS cable.
IMPORTANT
Procedure
1
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
When connecting miniSAS cables, check the connector orientation and then
firmly push it all the way in.
When disconnecting miniSAS cables, use the pull-tab to extract the
connector.
Connect the miniSAS cables to the ETERNUS DX60/DX80.
Insert the miniSAS cable connectors in the controller 0 (CM#0) and controller 1 (CM#1)
SAS ports.
If only one SAS port is to be used, it should be port 0 on each CM.
Do not connect this cable to the SAS (OUT) port.
IMPORTANT
93
Copyright 2009 FUJITSU LIMITED