Fujitsu Eternus DX60 User Manual page 63

Chapter 2 Hardware
> 2.3 Flow from Installation to Operation
(from previous page)
5
Perform device initial setup using GUI.
- Set Date and Time
- Set Storage System Name
- Change Password
- Setup Network Environment
6
Perform basic settings using GUI's Configuration Wizard.
- Create RAID Group
- Create Volume
- Define Host
- Define LUN Mapping
7
Perform the following settings (as required).
8
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Device Settings (Initial Settings)
Device Settings (Basic Settings)
Other Settings
1
Hot Spare Registration
Each added hot spare should be registered as such.
2
Port Parameter Setting
Set the device's host ports to allow them to connect to the server.
3
Advanced Copy Setting
If the Advanced Copy functions are to be used, set them up.
4
AC Auto Interlocking Mode
When setting the AC Auto Interlocking mode, turn on the AUTO POWER Switch of the
controller enclosure.
5
Maintenance Settings
Setup the device to allow any required post-installation maintenance procedures.
If e-mail notification of device errors is to be used, set a recipient e-mail address.
If the device is connected to a PRIMERGY server and the "ServerView" server monitoring tool
is to be used, perform the settings required for SNMP Trap Transfers.
If the Remote Notice function is to be used, perform the settings required to allow the device to
connect to a Fujitsu remote server.
6
Settings for Connecting Server
Perform the settings required to connect to the server. Install the drivers and perform the Fibre Channel
switch setting.
Operation and Troubleshooting
"4.3.3 Configuration Wizard"
"4.3.4 Hot Spare Registration"
"4.3.5 Port Parameters Setup"
"4.3.6 Advanced Copy Setup"
"4.3.7 AC Automatic Linkage Mode Setup"
"4.4 Maintenance Setup"
"4.5 Setting up the Server Connection"
"Chapter 6 Operation and Troubleshooting"
63
"4.3.2 Initial Setup"
Copyright 2009 FUJITSU LIMITED