Chapter 4 Setup; Prior Preparation - Fujitsu Eternus DX60 User Manual

Chapter 4
This chapter explains how to setup the ETERNUS DX60/DX80.
You may contact your sales representative or your maintenance engineer to perform this steps,
or alternatively perform them by yourself.
4.1

Prior Preparation

The following preparations are required before starting the ETERNUS DX60/DX80 setup:
Network settings
Determine the following network settings:
IP address and subnet mask for the ETERNUS DX60/DX80's MNT port of Master CM
(required)
P3AM-3042-03ENZ0 ETERNUS DX60/DX80 Disk storage system User Guide
Setup
Do
CAUTION
• Make sure to wear a wrist strap before starting each operation, as
failure to discharge static electricity may cause a device failure.
Do not remove it until the operation is complete.
• When the disk is brought from a cold to a warm place, there is a
chance that the change in temperature can result in condensation
forming on the magnetic platters. Wait for the disks to warm up to
the local ambient temperature before turning the ETERNUS DX60/
DX80 on.
Default IP address: 192.168.1.1
Default subnet mask 255.255.255.0
For dual controller model, a controller for which a LAN port for the
operation management of the ETERNUS DX60/DX80 is effective, is
called a "Master CM". The other controller is called a "Slave CM".
Single controller model only has a "Master CM" controller.
81
Copyright 2009 FUJITSU LIMITED