Port Display-Blackdiamond 8800 Family Of Switches Only - Extreme Networks ExtremeWare XOS Guide Manual

Configuring Slots and Ports on a Switch
Port Display—BlackDiamond 8800 Family of Switches Only
The following command displays more specific information for slot 3, port 1 on an BlackDiamond 8810
switch:
show ports 3:1 information detail
Following is sample output from this command:
Port: 3:1
Virtual-router: VR-Default
Type:
Random Early drop:
Admin state:
Link State:
Link Counter: Up
VLAN cfg:
STP cfg:
Protocol:
Trunking:
EDP:
DLCS:
lbDetect:
Learning:
Unicast Flooding:
Multicast Flooding:
Broadcast Flooding:
Jumbo:
BG QoS monitor: Unsupported
Egress Port Rate:
Broadcast Rate:
Multicast Rate:
Unknown Dest Mac Rate:
QoS Profile:
Ingress Rate Shaping :
Ingress IPTOS Examination:
Egress IPTOS Replacement:
Egress 802.1p Replacement:
NetLogin:
NetLogin authentication mode:
NetLogin port mode:
Smart redundancy:
Software redundant port:
autopolarity:
144
UTP
Disabled
Enabled with
Active, 1 Gbps, full-duplex
1 time(s)
Name: Default, Internal Tag = 1 (MAC-Based), MAC-limit = No-limit
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Name: Default Protocol: ANY
Load sharing is not enabled.
Enabled
Unsupported
Unsupported
Enabled
Enabled
Enabled
Enabled
Disabled
128 Kbps, Max Burst Size: 200 Kb
No-limit
No-limit
No-limit
QP3 configured by user
auto-speed sensing auto-duplex
Match all protocols.
Unsupported
Disabled
Disabled
Disabled
Enabled
MAC based
MAC based VLANs
Enabled
Disabled
Enabled
ExtremeWare XOS 11.3 Concepts Guide