Ospf Wait Interval Parameters - Extreme Networks ExtremeWare XOS Guide Manual

OSPF
configure ospf area <area-identifier> timer <retransmit-interval> <transit-delay>
<hello-interval> <dead-interval> {<wait-timer-interval>}
configure ospf virtual-link <router-identifier> <area-identifier> timer <retransmit-
interval> <transit-delay> <hello-interval> <dead-interval>
configure ospf vlan [<vlan-name> | all] timer <retransmit-interval> <transit-delay>
<hello-interval> <dead-interval> {<wait-timer-interval>}

OSPF Wait Interval Parameters

You can configure the following parameters:
Retransmit interval—The length of time that the router waits before retransmitting an LSA that is not
●
acknowledged. If you set an interval that is too short, unnecessary retransmissions result. The
default value is 5 seconds.
Transit delay—The length of time it takes to transmit an LSA packet over the interface. The transit
●
delay must be greater than 0.
Hello interval—The interval at which routers send hello packets. Shorter times allow routers to
●
discover each other more quickly but also increase network traffic. The default value is 10 seconds.
Dead router wait interval (Dead Interval)—The interval after which a neighboring router is declared
●
down because hello packets are no longer received from the neighbor. This interval should be a
multiple of the hello interval. The default value is 40 seconds.
Router wait interval (Wait Timer Interval)—The interval between the interface coming up and the
●
election of the DR and BDR. This interval should be greater than the hello interval. If this time is
close to the hello interval, the network synchronizes very quickly but might not elect the correct DR
or BDR. The default value is equal to the dead router wait interval.
NOTE
The OSPF standard specifies that wait times are equal to the dead router wait interval.
552
ExtremeWare XOS 11.3 Concepts Guide