Emistp Configuration Example - Extreme Networks ExtremeWare XOS Guide Manual

Configures the default encapsulation mode of dot1d for all ports added to STPD Backbone_st.
●
Enables autobind to automatically add or remove ports from the STPD.
●
Assigns the Engineering VLAN to the STPD.
●
Assigns the carrier VLAN.
●
Enables STP.
●
configure vlan default delete ports 2:5-2:10
create vlan engineering
configure vlan engineering tag 150
configure vlan engineering add ports 2:5-2:10 untagged
create stpd backbone_st
configure stpd backbone_st default-encapsulation dot1d
enable stpd backbone_st auto-bind vlan engineering
configure stpd backbone_st tag 150
enable stpd backbone_st
By default, the port encapsulation mode for user-defined STPDs is
.
dot1d

EMISTP Configuration Example

Figure 47 is an example of EMISTP.
Figure 47: EMISTP configuration example
VLAN red
S1
VLAN green
VLAN red
S3
VLAN blue
NOTE
By default, all ports added to a user-defined STPD are in emistp mode, unless otherwise specified.
The following commands configure the switch located between S1 and S2:
create vlan red
configure red tag 100
configure red add ports 1:1-1:4 tagged
create vlan green
configure green tag 200
ExtremeWare XOS 11.3 Concepts Guide
S2
VLAN yellow
VLAN red
STP Configuration Examples
. In this example, you set it to
emistp
VLAN red
S4
VLAN brown
EX_051
449