Extreme Networks ExtremeWare XOS Guide Manual page 305

To verify settings on ports or VLANs, use the following command:
show ports {mgmt | <port_list>} information {detail}
BlackDiamond 8800 family of switches and Summit X450 switch display. You display which QoS profile, if
any, is configured on the BlackDiamond 8800 family of switches and the Summit X450 switch using the
show ports <port_list> information detail
command for an BlackDiamond 8810 switch:
Port: 8:1
Virtual-router: VR-Default
Type:
Random Early drop:
Admin state:
Link State:
Link Counter: Up
VLAN cfg:
Name: Default, Internal Tag = 1, MAC-limit = No-limit
STP cfg:
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Protocol:
Name: Default
Trunking:
EDP:
DLCS:
lbDetect:
Learning:
Flooding:
Jumbo:
BG QoS monitor: Unsupported
Egress Port Rate:
Broadcast Rate:
Multicast Rate:
Unknown Dest Mac Rate:
QoS Profile:
Ingress Rate Shaping :
Ingress IPTOS Examination:
Egress IPTOS Replacement:
Egress 802.1p Replacement:
NetLogIn:
Smart redundancy:
Software redundant port:
NOTE
To ensure that you display the QoS information, you must use the detail variable.
BlackDiamond 10K switch display. You display information on the egress QoS profiles and the ingress
QoS profiles (shown as Ingress Rate Shaping), as well as the minimum and maximum available
bandwidth and priority on the BlackDiamond 10 K switch using the
command. The display is slightly different for a 1 Gbps port and for a 10 Gbps
information detail
port.
ExtremeWare XOS 11.3 Concepts Guide
command. Following is a sample output of this
EW
Disabled
Enabled with auto-speed sensing
Active
1 time(s)
Protocol: ANY
Load sharing is not enabled.
Enabled
Unsupported
Unsupported
Enabled
Enabled
Disabled
No-limit
No-limit
No-limit
No-limit
Qp3 Configured by user
Unsupported
Disabled
Disabled
Disabled
Disabled
Enabled
Disabled
Traffic Groupings
auto-duplex
Match all protocols.
show ports <port_list>
305