Extreme Networks ExtremeWare XOS Guide Manual page 159

To advertise the IP address of the management VLAN (or the system MAC address if IP is not
configured), issue the following command:
configure lldp ports [all | <port_list>] [advertise | no-advertise] management-
address
You can advertise more than one VLAN name per LLDP-enabled port. To do so, add one optional
VLAN name TLV for each VLAN you want to advertise. If you do not specify VLAN names, the system
sends an advertisement for all VLANs on the port.
To advertise VLAN names, issue the following command:
configure lldp ports [all | <port_list>] [advertise | dont-advertise] vendor-
specific dot1 vlan-name {vlan [all | <vlan_name>]}
NOTE
The total LLPDU size is 1500 bytes; any TLVs after that limit are dropped.
You can advertise the untagged, port-based VLAN for the LLDP-enabled port using the port VLAN ID
TLV. Configure the port VLAN ID TLV by issuing the following command:
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-specific
dot1 port-vlan-ID
You can advertise more than one protocol-based VLAN per LLDP-enabled port. To do so, add one
optional port and protocol VLAN ID TLV for each VLAN you want to advertise. To advertise these
VLANs, issue the following command:
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-specific
dot1 port-protocol-vlan-ID {vlan [all | <vlan_name>]}
NOTE
The total LLPDU size is 1500 bytes; any TLVs after that limit are dropped.
You can advertise the speed capabilities, autonegotiation support and status and physical interface of
the LLDP-enabled port using the MAC/PHY configuration/status TLV. To advertise this information,
issue the following command:
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-specific
dot3 mac-phy
Configure the power via MDI TLV to advertise the PoE capabilities of the LLDP-enabled port. Issue the
following command to advertise the PoE capabilities and status:
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-specific
dot3 power-via-mdi
You advertise the load-sharing capabilities and status of the LLDP-enabled port by configuring the link
aggregation TLV. To advertise load-sharing capabilities, issue the following command:
configure lldp ports [all | <port_list>] [advertise | no-advertise] vendor-specific
dot3 link-aggregation
ExtremeWare XOS 11.3 Concepts Guide
Configuring LLDP
159