Configuring An Esrp Domain On A Switch - Extreme Networks ExtremeWare XOS Guide Manual

Extreme Standby Router Protocol
Table 63: ESRP election algorithms (Continued)
Election Algorithm
sticky > priority > track > ports > mac
sticky > priority > mac
sticky > track > ports > priority
track > ports > priority
track > ports > priority > mac
CAUTION
All switches in the ESRP network must use the same election algorithm, otherwise loss of connectivity, broadcast
storms, or other unpredictable behavior may occur.
NOTE
If you have a network that contains a combination of switches running ExtremeWare XOS and ExtremeWare, only the
ports-track-priority-mac election algorithm is compatible with ExtremeWare releases prior to version 6.0.

Configuring an ESRP Domain on a Switch

To create, configure, and enable a basic ESRP domain, complete the following steps:
1 Create and configure the master VLAN.
2 Create and configure the member VLAN(s), if applicable.
3 Create the ESRP domain.
4 Configure the ESRP domain ID, if applicable.
5 Add the master VLAN to the ESRP domain.
6 Add the member VLAN(s) to the ESRP domain, if applicable.
7 Enable ESRP for the specified ESRP domain.
The instructions that follow assume that you have already created and configured the VLANs to use as
the ESRP domain master and member VLANs. For more information about creating VLANs, see
Chapter 5, Virtual LANs. For more information about ESRP master and member VLANs, see
VLANs to an ESRP Domain" on page
You can also configure other ESRP domain parameters, including ESRP:
Mode of operation as described in
●
Timers as described in the ExtremeWare XOS Command Reference Guide.
●
466
Description
Specifies that this ESRP domain should consider election factors in
the following order: Stickiness, ESRP priority, tracking information,
active ports, MAC address.
Specifies that this ESRP domain should consider election factors in
the following order: Stickiness, ESRP priority, MAC address.
Specifies that this ESRP domain should consider election factors in
the following order: Stickiness, tracking information, active ports,
ESRP priority.
Specifies that this ESRP domain should consider election factors in
the following order: Tracking information, active ports, ESRP priority.
Specifies that this ESRP domain should consider election factors in
the following order: Tracking information, active ports, ESRP priority,
MAC address.
468.
"Standard and Extended ESRP" on page
"Adding
459.
ExtremeWare XOS 11.3 Concepts Guide