Extreme Networks ExtremeWare XOS Guide Manual page 45

Table 7: Common commands (Continued)
Command
configure ssh2 key {pregenerated}
configure sys-recovery-level [all |
none]
configure time <month> <day> <year>
<hour> <min> <sec>
configure timezone {name <tz_name>}
<GMT_offset> {autodst {name
<dst_timezone_ID>} {<dst_offset>}
{begins [every <floatingday> | on
<absoluteday>] {at <time_of_day>}
{ends [every <floatingday> | on
<absoluteday>] {at <time_of_day>}}} |
noautodst}
configure vlan <vlan_name> ipaddress
[<ipaddress> {<ipNetmask>} | ipv6-link-local |
{eui64} <ipv6_address_mask>]
create account [admin | user]
<account-name> {encrypted <password>
}
create vlan <vlan_name> {vr <vr-
name>}
delete account <name>
delete vlan <vlan_name>
disable bootp vlan [<vlan> | all]
disable cli-config-logging
disable clipaging
disable idletimeout
disable port [<port_list> | all]
disable ssh2
disable telnet
enable bootp vlan [<vlan> | all]
enable cli-config-logging
ExtremeWare XOS 11.3 Concepts Guide
Description
Generates the SSH2 host key.
You must install the SSH software module in addition to
the base image to run SSH.
Configures a recovery option for instances where an
exception occurs in ExtremeWare XOS.
Configures the system date and time. The format is as
follows:
mm dd yyyy hh mm ss
The time uses a 24-hour clock format. You cannot set the
year earlier than 2003 or past 2036.
Configures the time zone information to the configured
offset from GMT time. The format of GMT_offset is +/-
minutes from GMT time. The autodst and noautodst
options enable and disable automatic Daylight Saving Time
change based on the North American standard.
Additional options are described in the ExtremeWare XOS
Command Reference Guide.
Configures an IP address and subnet mask for a VLAN.
Creates a user account. This command is available to
admin-level users and to users with RADIUS command
authorization. The username is between 1 and 32
characters, the password is between 0 and 32 characters.
Creates a VLAN.
NOTE: The BlackDiamond 8800 family of switches
(formerly known as Aspen) and the Summit X450 switch do
not use the vr optional parameter.
Deletes a user account.
Deletes a VLAN.
Disables BOOTP for one or more VLANs.
Disables logging of CLI commands to the Syslog.
Disables pausing of the screen display when a show
command output reaches the end of the page.
Disables the timer that disconnects all sessions. After
being disabled, console sessions remain open until the
switch is rebooted or until you log off. Telnet sessions
remain open until you close the Telnet client.
Disables one or more ports on the switch.
Disables SSH2 Telnet access to the switch.
You must install the SSH software module in addition to
the base image to run SSH.
Disables Telnet access to the switch.
Enables BOOTP for one or more VLANs.
Enables the logging of CLI configuration commands to the
Syslog for auditing purposes. The default setting is
enabled.
Common Commands
45