Chapter 24: Ipv6 Unicast Routing; Overview Of Ipv6 Unicast Routing - Extreme Networks ExtremeWare XOS Guide Manual

24 IPv6 Unicast Routing
This chapter covers the following topics:
This chapter describes the following topics:
Overview of IPv6 Unicast Routing on page 515
●
Router Interfaces on page 516
●
Specifying IPv6 Addresses on page 516
●
Neighbor Discovery Protocol on page 518
●
Populating the Routing Table on page 519
●
Configuring IP Unicast Routing on page 522
●
Verifying the IP Unicast Routing Configuration on page 522
●
Routing Configuration Example on page 522
●
This chapter assumes that you are already familiar with IPv6 unicast routing. If not, refer to the
following publications for additional information:
RFC 2460—Internet Protocol, Version 6 (IPv6) Specification
●
RFC 3513—Internet Protocol Version 6 (IPv6) Addressing Architecture
●
NOTE
For more information on interior gateway protocols, see

Overview of IPv6 Unicast Routing

The switch provides full Layer 3, IPv6 unicast routing. It exchanges routing information with other
routers on the network using either the IPv6 version of Routing Information Protocol (RIPng) or the
IPv6 version of Open Shortest Path First (OSPFv3) protocol. The switch dynamically builds and
maintains a routing table and determines the best path for each of its routes.
Beginning in release 11.2, ExtremeWare XOS can provide both IPv4 and IPv6 routing at the same time.
Separate routing tables are maintained for the two protocols. Most commands that require you to
specify an IP address can now accept either an IPv4 or IPv6 address and act accordingly. Additionally,
many of the IP configuration, enabling, and display commands have added tokens for IPv4 and IPv6 to
clarify the version required. For simplicity, existing commands affect IPv4 by default and require you to
specify IPv6, so configurations from an earlier release will still correctly configure an IPv4 network.
ACLs and routing policies also support IPv6. Use an IPv6 address in a rule entry will automatically use
IPv6.
NOTE
IPv6 functionality is supported only on the virtual routers VR-Default and VR-Mgmt. VR-Mgmt supports only IPv6
addressing and static routing; VR-Default also supports dynamic routing.
ExtremeWare XOS 11.3 Concepts Guide
Chapter 26, RIPng or Chapter 28, OSPFv3.
515